Unlike Wall Cutter which does not allow cutting deeper than the radius of diamond blade,
Plunge cutter enables cutting of thick reinforced concrete deeper than the diameter of blade
by plunging its rotation axis into pilot hole which has to be drilled before plunging.
■
Can be opened □350mm~□400mm quadrilateral hole only one anchor bolt and four
pilot hole.
■
The Plunge Cutter consists of three units, Main body, Pole Base, and Cover.
■
Diamond blade, Drill Head and 4” Core bit are required for execution.
Plunge Cutter PC-16
※
Drill Head SPN202series
※
Plunge Cutter PC-16
※
49v49 Pole Base for Plunge Cut
※
Plunge Cut Cover
※
Adapter Unify 11/4→A Thread
Opening procedure
1.
Make four pieces of pilot holes
2.
Chage the Core Bit to Main Body of Plunge Cut PC-16.